WattsCraft finger throttle

Finger throttle assembly for jet boats. Includes:

  • Aluminium body, finger lever, cable pull lever

  • 8mm Stainless shaft

  • 12 x M5 Stainless steel bolts

  • 2 x M6 Stainless steel grub-screws

  • 4 x X-Lube collared nylon bushes

  • 1 x Removable bolt-on 6mm barrel nipple

35mm pull - Suits jetski engines & 1.5mm diameter control cable. Modification of throttle linkage at motor end may be nessesary for automotive engines.

70 x 6 PCD Suits most aftermarket steering wheels (Momo, Nardi, el cheapos etc). Works with hollow shaft steering coulmn, WattsCraft spec SSS engineering shaft shown.

50mm deep, i.e. adds 50mm to steering column length.

Suits steering wheels with shallow dish/offset. Finger lever can be rotated on shaft to suit different dish measurements.

Customer will need to drill two holes for shaft locking grub-screws to locate into. Holes to be drilled after the relative angles of the finger lever & cable pull lever are determined. This is a stainless shaft so a drill press and vee block are recommended for best results.

Assembly instructional video here